Como Programar Descalcificador Cillit Data _verified_ May 2026

def calculate_remaining_capacity(): # Remaining softening capacity (liters) # capacity_total = resin volume (L) * exchange capacity (eq/L) / hardness (eq/L) available_capacity_liters = capacity_total / hardness_raw

Since Cillit softeners are rebranded versions of BWT / Judo / Grünbeck technology (common in Europe), the programming logic applies to any . Programming a Cillit Water Softener: The Control Logic Modern Cillit softeners use a microcontroller (often a 16-bit PIC or STM) that tracks water flow, regenerates resin, and manages salt consumption. Below is the pseudo-code and logic blocks for programming the device. 1. Core Variables (EEPROM stored) // Cillit Softener Parameters float capacity_total = 1200.0; // Total hardness removal capacity (grains or °dH * liters) float flow_rate_lpm = 0.0; // Instant flow from turbine sensor (L/min) float total_flow_m3 = 0.0; // Cumulative water since last regeneration (m³) int hardness_raw = 25; // Inlet water hardness (set via installer menu, e.g., 25 °fH) int residual_hardness = 0; // Target residual (usually 0 for soft) int regeneration_time_hour = 2; // Regenerate at 2:00 AM 2. Hardness Capacity Calculation The system calculates how many liters it can treat before regeneration is required. como programar descalcificador cillit data

void loop() // 1. Read current hardness (could be from an inline sensor or manual input) hardness_raw = read_user_hardness_setting(); // 2. Calculate consumed capacity float consumed = total_flow_m3 * 1000 * hardness_raw; // in grams equivalent void loop() // 1

// 3. Decide if regeneration needed if ( (capacity_total - consumed) < (capacity_total * 0.15) ) // less than 15% capacity left schedule_regeneration(); On a physical Cillit device

// Step 2: Brine draw (pull salt water from brine tank) move_valve_to(BRINE_DRAW); delay_minutes(60); // typical Cillit: 45-90 min depending on model

// Log regeneration log_event("Regeneration completed", get_timestamp()); On a physical Cillit device, you'd enter programming mode by holding SET + UP for 5 seconds.

Cillit uses a piston or rotary disc valve with position feedback.